Machinery Wiki

How a CNC Router Works: Gantry, Vacuum Table, Tooling and Nesting

The core idea: a CNC router moves a rotating cutter through a panel held on a vacuum table, guided by a program. It cuts shaped parts, drills and grooves in one setup — the machine that makes nesti

By Global Machinery Hub Editorial Team · Published November 17, 2026 · 3 min read

The core idea: a CNC router moves a rotating cutter through a panel held on a vacuum table, guided by a program. It cuts shaped parts, drills and grooves in one setup — the machine that makes nesting production possible.

The main assemblies

Gantry and axes. A beam (gantry) carries the machining head across the table in X and Y; the head moves up and down in Z. Three-axis machines cut from above only; four- and five-axis heads tilt the spindle so undercuts and angled holes can be machined without repositioning the panel.

Workholding

Panels are held by vacuum: the table is divided into zones, each connected to a vacuum pump, and a spoil board on top is machined flat so the vacuum can pull through it. Small parts need either a smaller zone, a gasket, or tabs left in the program so the part does not move when the last cut frees it.

Tooling and tool change

Nesting programs typically use a small cutter for detail, a larger cutter for long straight runs, and a drill block for shelf-pin and dowel holes. An automatic tool changer swaps tools between operations, which is what allows one program to cut, drill and groove without an operator touching the machine.

Nesting

Nesting software arranges the parts of a job on each board so the material is used efficiently, then generates the toolpaths. Because parts are cut from a full board rather than from pre-cut strips, the same machine handles one-offs and batches — but the cycle time per part is usually higher than a beam saw plus edgebander line, and the spoil board has to be skimmed regularly.

Where a router fits

  • Shaped and curved parts — anything that is not a rectangle.
  • Mixed batches — many different parts in one shift without saw setup.
  • Grooving, drilling and hinge pockets — in the same setup as the outline cut.

For pure rectangular panel furniture at high volume, a beam saw plus edgebander is usually faster per part. For shaped work, small batches and mixed production, a nesting router removes several handling steps.

What decides cut quality

  • Rigidity — a flexing gantry leaves chatter marks on the cut edge.
  • Spindle runout and tool condition — dull tools burn the edge instead of shearing it.
  • Vacuum and spoil board condition — poor hold-down lets the panel lift and the cut depth change.
  • Feed and speed matching — too fast for the material leaves a rough edge; too slow burns it.

Last verified: November 17, 2026.